The Synergistic Antibacterial Performance of a Cu/WO3-Added PTFE Particulate Superhydrophobic Composite Material
Read full paper at:
http://www.scirp.org/journal/PaperInformation.aspx?PaperID=52927#.VKyjCMnQrzE
http://www.scirp.org/journal/PaperInformation.aspx?PaperID=52927#.VKyjCMnQrzE
Affiliation(s)
1Collaborative Research Center, Daido University, Nagoya, Japan.
2Kanagawa Academy of Science and Technology, Kawasaki, Kanagawa, Japan.
2Photocatalysis International Research Center, Tokyo University of Science, Tokyo, Japan.
4Department of Information Design, Daido University, Nagoya, Japan.
2Kanagawa Academy of Science and Technology, Kawasaki, Kanagawa, Japan.
2Photocatalysis International Research Center, Tokyo University of Science, Tokyo, Japan.
4Department of Information Design, Daido University, Nagoya, Japan.
ABSTRACT
The
synergistic antibacterial performance against Escherichia coli (E.
coli), Staphylococcus aureus and methicillin-resistant Staphylococcus
aureus (MRSA) of a Cu/WO3-added PTFE
(polytetrafluoroethylene) particulate composite was reported in the
previous paper. The origin of the synergistic antibacterial performance
investigated by evaluating the photocatalytic decomposition of the Cu/WO3-added PTFE particulate composite material is reported in the present paper. Addition of Cu/WO3,
visible-light-sensitive photocatalyst, to the PTFE particle dispersed
superhydrophobic composite does not deteriorate the superhydrophobic
property of the composite. Furthermore the existence of the
polytetrafluoroethylene (PTFE) particles dispersed in the composite
enhances the antibacterial property caused by the Cu/WO3. The authors call this “The synergistic effect”. In this study, a novel synergistic property of the Cu/WO3-added
PTFE particulate composite was investigated by evaluating the
degradation of gaseous acetaldehyde on the composite surface using
visible light (10,000 lx) and UV-A (1 mW·cm-1) illumination. The 12 wt% Cu/WO3-8 wt% binder-80 wt% PTFE composite shows the synergistic visible-light-sensitive photocatalytic property. But 12 wt% Cu/WO3-44
wt% PTFE-44 wt% binder composite no longer shows the synergistic
property of visible-light-sensitive photocatalytic property. The
synergetic performance of visible-light-sensitive photocatalytic
property appears only when PTFE concentration is larger than the
critical point over which superhydrophobic property appears in
accordance with the particulate composite model derived by the one of
the authors. The hydrophobic surface leads to the low surface free
energy derived by the revised Fowkes’s theory, which makes it difficult
for bacteria to stick to the hydrophobic surface of the composite. Even
if bacteria stick to the surface, they are decomposed by the
visible-light-sensitive photocatalyst. This is the reason why the
synergistic antibacterial performance against bacteria appears.
KEYWORDS
Cu/WO3, Photocatalyst, PTFE, Hydrophobicity, Particulate, Composite, Synergistic Antibacterial Performance, Escherichia coli, MRSA
Cite this paper
References
Yamauchi, K. , Ochiai, T. and Yamauchi, G. (2015) The Synergistic Antibacterial Performance of a Cu/WO3-Added PTFE Particulate Superhydrophobic Composite Material. Journal of Biomaterials and Nanobiotechnology, 6, 1-7. doi: 10.4236/jbnb.2015.61001.
| [1] | Yamauchi, G., Saito, H. and Takai, K. (2000) PTFE Based Water Repellent Coating for Telecommunication Antennas. IEICE Transactions on Electronics, E83-C, 1139-1141. |
| [2] | Saito, H., Takai, K., Takazawa, H. and Yamauchi, G. (1997) A Study on Snow Sticking Weight to Water Repellent Coaing. Materials Science Research International, 3, 216-219. |
| [3] | Hsieh,
C.-T., Chen, J.-M., Kuo, R.-R., Lin, T.-S. and Wu, C.-F. (2005)
Influence of Surface Roughness on Water- and Oil-Repellent Surfaces
Coated with Nanoparticles. Applied Surface Science, 240, 318-326. http://dx.doi.org/10.1016/j.apsusc.2004.07.016 |
| [4] | Yao, Y., Ohko, Y., Sekiguchi, Y., Fujishima, A. and Kubota, Y. (2008) Self-Sterilization Using Silicone Catheters Coated with Ag and TiO2 Nanocomposite Thin Film. Journal of Biomedical Materials Research Part B: Applied Biomaterials, 85B, 453-460. http://dx.doi.org/10.1002/jbm.b.30965 |
| [5] | Yao,
Y., T. Ochiai, T., Ishiguro, H., Nakano, R. and Kubota, Y. (2011)
Antibacterial Performance of a Nobel Photocatalytic Coated Cordierite
Foam for Use in Air Cleaners. Applied Catalysis B: Environmental, 106,
592-599. http://dx.doi.org/10.1016/j.apcatb.2011.06.020 |
| [6] | Dunlop, P.S.M., Sheeran, C.P., Byrne, J.A., McMahon, M.A.S., Boyle, M.A. and McGuigan, K.G. (2010) Inactivation of Clinically Relevant Pathogens by Photocatalytic Coatings. Journal of Photochemistry and Photobiology A: Chemistry, 216, 303-310. http://dx.doi.org/10.1016/j.jphotochem.2010.07.004 |
| [7] | Irie, H., Washizuka, S., Yoshino, N. and Hashimoto, K. (2003) Visible-Light Induced Hydrophilicity on Nitrogen-Sub- stituted Titanium Dioxide Films. Chemical Communications, 9, 1298-1299. http://dx.doi.org/10.1039/b302975a |
| [8] | Kitano, M., Funatsu, K., Matsuoka, M., Ueshima, M. and Anpo, M. (2006) Preparation of Nitrogen-Substituted TiO2 Thin Film Photocatalysts by the Radio Frequency Magnetron Sputtering Deposition Method and Their Photocatalytic Reactivity under Visible Light Irradiation. Journal of Physical Chemistry B, 110, 25266-25272. |
| [9] | Kamali, H.E., Marzbanrad, E., Zamani, C. and Raissi, B. (2009) Nanocasting Synthesis of Ultrafine WO3 Nanoparticles for Gas Sensing Applications. Nanoscale Research Letters, 5, 370-373. |
| [10] | Xi,
G., Yue, B., Cao, J. and Ye, J. (2011) Fe3O4Hierachical Core-Shell
Structure: High-Performance and Recyclable Visible-Light Photocatalysis.
Chemistry—A European Journal, 17, 5145-5154. http://dx.doi.org/10.1002/chem.201002229 |
| [11] | Ashokumar,
M. and Maruthamuthu, P. (1989) Preparation and Characterization of
Doped WO3 Photocatalyst Powders. Journal of Materials Science, 24,
2135-2139. http://dx.doi.org/10.1007/BF02385433 |
| [12] | Irie, H., Miura, S., Kamiya, K. and Hashimoto, K. (2008) Efficient Visible Light-Sensitive Photocatalysis: Grafting Cu(Ⅱ) Ions onto TiO2 and WO3 Photocatalysis. Chemical Physics Letters, 457, 202-205. |
| [13] | Yao,
Y., Yamauchi, K., Yamauchi, G., Ochiai, T., Murakami, T. and Kubota, Y.
(2012) Synergistic Antibacterial Performance of a Cu/WO3-Added PTFE
Particulate Superhydrophobic Composite under Visible-Light Exposure.
Journal of Biomaterials and Nanobiotechnology, 3, 421-431. http://dx.doi.org/10.4236/jbnb.2012.34042 |
| [14] | JIS R 1701-2 (2008) Fine Ceramics (Advanced Ceramics, Advanced Technical Ceramics)—Test Method for Air Purification Performance of Photocatalytic Materials—Part 2: Removal of Acetaldehyde. |
| [15] | Leonaldos,
G., Kendole, D. and Barnard, N. (1969) Odor Threshold Determinations of
53 Odorant Chemicals. Journal of the Air Pollution Control Association,
19, 91-95. http://dx.doi.org/10.1080/00022470.1969.10466465 |
| [16] | AmooreJ, E. and Hautala, E. (1983) Odor as an Aid to Chemical Safety: Odor Thresholds Compared with Threshold Limit Values and Volatilities for 214 Industrial Chemicals in Air and Water Dilution. Journal of Applied Toxicology, 3, 272-290. http://dx.doi.org/10.1002/jat.2550030603 |
| [17] | Yamauchi,
K., Yamauchi, G. and Takai, K. (2011) Wetting Characteristics of
Different Types of Liquid on Particulate Composite Materials. Journal of
the Society of Materials Science, Japan, 60, 259-264. http://dx.doi.org/10.2472/jsms.60.259 |
| [18] | Yamauchi,
G., Miller, J.D., Saito, H., Takai, K., Takazawa, H. and Ueda, T.
(1996) The Wetting Characteristics of PTFE Particulate Composites.
Materials Transactions, 37, 721-728. http://dx.doi.org/10.2320/matertrans1989.37.721 |
| [19] | Cassie, A.B.D. (1948) Contact Angle. Discussions of the Faraday Society, 3, 11-16. http://dx.doi.org/10.1039/df9480300011 |
| [20] | Kitazaki, Y. and Hata, T. (1972) Revision of the Fowkes’s Formula and Evaluation of Surface Energy of High Molecule Solid Material. Journal of the Adhesion Society of Japan, 8, 131-137. eww150107lx |
评论
发表评论