Assessment and Development of Two Phase Turbulent Mixing Models for Subchannel Analysis Relevant to BWR
Read full paper at:
http://www.scirp.org/journal/PaperInformation.aspx?PaperID=50339#.VDdHE1fHRK0
http://www.scirp.org/journal/PaperInformation.aspx?PaperID=50339#.VDdHE1fHRK0
Author(s)
Determination of turbulent mixing rate of two phase
flow between neighboring subchannels is an important aspect of sub
channel analysis in reactor rod bundles. Various models have been
developed for two phase turbulent mixing rate between subchannels. These
models show that turbulent mixing rate is strongly dependent on flow
regimes; their validity was examined against specific or limited
experiments. It is vital to evaluate these models by comparing the
predicted two phase turbulent mixing rate with available experimental
data conducted for various subchannel geometries and operating
conditions. This paper describes evaluation of different models for two
phase turbulent mixing rate for both gas and liquid phase against large
range of experimental data which are obtained from various subchannel
geometries. The results indicate that there is large discrepancy between
the predicted and experimental data for turbulent mixing rate. This
paper provides important shortcoming of the previous work and need for
the development of a new model. In the view of this, a two phase flow
model is presented, which predicts both liquid and gas phase turbulent
mixing rate between adjacent sub channels of reactor rod bundles. The
model presented here is for slug churn flow regime, which is dominant as
compared to the other regimes like bubbly flow and annular flow
regimes, since turbulent mixing rate is the highest in slug churn flow
regime. The present model has been tested against low pressure and
temperature air-water and high pressure and temperature steam-water
experimental data found that it shows good agreement with available
experimental data.
Cite this paper
Sharma, M. and Nayak, A. (2014) Assessment and
Development of Two Phase Turbulent Mixing Models for Subchannel Analysis
Relevant to BWR. World Journal of Nuclear Science and Technology, 4, 195-207. doi: 10.4236/wjnst.2014.44025.
| [1] | Lahey Jr., R.T. andMoody, F.J. (1993) The Thermal Hydraulics of Boiling Water Nuclear Reactor. 2nd Edition, ANS, La Grange Park. |
| [2] | Walton, F.B. (1969) Turbulent Mixing Measurements for Single-Phase Air, Single-Phase Water and Two-Phase Air-Water Flows in Adjacent Triangular Subchannels. M.Sc. Thesis, Department of Chemical Engineering, University of Windsor, Windsor. |
| [3] | Rudzinski, K.F. (1970) Two-Phase Turbulent Mixing for Air-Water Flows in Adjacent Triangular Subchannels. M.Sc. Thesis, Department of Chemical Engineering, University of Windsor, Windsor. |
| [4] | Singh, K.S. (1972) Air-Water Turbulent Mixing in Simulated Rod Bundle Geometries. Ph.D. Thesis, Department of Chemical Engineering, University of Windsor, Windsor. |
| [5] | Kawahara, A., Sadatomi, M. and Sato, Y. (1997) Two-Phase Turbulent Mixing between Subchannels in a Simulated Rod Bundle Geometry—The Effect of the Number of Gaps between Subchannels. Proceedings of the 2nd JapaneseGerman Symposium on Multi-Phase Flow, Tokyo, 25-27 September 1997, 55-64. |
| [6] | Sadatomi, M., Kawahara, A., Kano, K. and Sumi, Y. (2004) Single and Two-Phase of Turbulent Mixing Rate between Adjacent Subchannels in a Vertical 2 × 3 Rod Array Channel. Nuclear Engineering and Design, 202, 27-38. |
| [7] |
Kawahara, A., Sadatomi, M.,
Kudo, H. and Kano, K. (2006) Single and Two Phase Turbulent Mixing Rate
between Subchannels in Triangle Tight Lattice Rod Bundle. JSME
International Journal, Series B, 49, 287-295. http://dx.doi.org/10.1299/jsmeb.49.287 |
| [8] | Bues, S.G. (1972) Two Phase Turbulent Mixing Model for Flow in Rod Bundle. Report WAPD-T-2438. Bettis Atomic Power Laboratory. Pittsburgh. |
| [9] | Kazimi, M.S. and Kelly, J.E. (1983) Formulation of Two Fluid Model for Mixing in LWR Bundle. In: Merilo, M., Ed., Thermal Hydraulics of Nuclear Reactor, ANS, Lagrange Park, Vol. 1, 433-439. |
| [10] |
Kawahara, A., Sadatomi, M. and
Sato, Y. (2000) Prediction of Turbulent Mixing Rate of Both Gas and
Iquid Phases between Adjacent Subchannels in a Two Phase Slug Churn
Flow. Nuclear Engineering and Design, 202, 27-38. http://dx.doi.org/10.1016/S0029-5493(00)00300-9 |
| [11] |
Carlucci, L.N., Hammouda, N. and
Rowe, D.S. (2003) Two Phase Turbulent Mixing and Buoyancy Drift In Rod
Bundle. Nuclear Engineering and Design, 227, 65-84. http://dx.doi.org/10.1016/j.nucengdes.2003.08.003 |
| [12] |
Rowe, D.S. and Angel, C.W.
(1969) Cross Flow Mixing between Parallel Flow Channel during Boiling.
Part III: Effect of Spacer on Mixing between Two Channels. Bettelle
Nortwest, BNWL-371. http://dx.doi.org/10.2172/4823782 eww141010lx |
评论
发表评论