跳至主要内容

Study on Ultimate Pullout Force of Grouting Anchors of the Anchor-Pull Retaining Wall

Read full paper at:
http://www.scirp.org/journal/PaperInformation.aspx?PaperID=52367#.VJOAZcCAM4

Determination of the grouting anchor pullout force is a key step during the design of anchor-pull retaining wall, but it is mostly determined relied on empirical formula at present, and the rationality and the safety cannot be effectively guaranteed. Based on the engineering case of the gravity retaining wall of Qinglin Freeway, the model test was designed, and combined with the results of the ABAQUS finite element numerical analysis, it was analyzed that how the anchor axial pulling force distributes. The results showed that the force of the anchor near the wall bolt was large and which far from the wall was small and the ultimate pullout force was proportional to the length, diameter and shear strength. When the end tension of the anchor was small, the top load played a leading role on the anchor tension. This conclusion confirmed the calculation formula of ultimate pullout force was and provided a theoretical basis for anchor-pull retaining wall design and calculation.
Cite this paper
Zhang, H. , Yu, Y. , Song, X. , Li, Y. and Wu, J. (2014) Study on Ultimate Pullout Force of Grouting Anchors of the Anchor-Pull Retaining Wall. Journal of Geoscience and Environment Protection, 2, 32-37. doi: 10.4236/gep.2014.25005. 
 

[1] Ge, L. D., & Zhu, H. B. (1999). Application of Anchor Retaining Wall. Beijing Water Conservancy, 1, 20-22.
[2] Liao, F. X., Chen, Y. K., & Yin, J. D. (2006) The Pressure Dispersion-Type Prestressed Anchor Cable Construction Technology. Subgrade Engineering, 1, 85-87.
[3] Ying, H. W., Jiang, B., & Xie, K. H. (2007). Considering Soil Arching Effect of Retaining Wall Active Soil Pressure Distribution. Chinese Journal of Geotechnical Engineering, 29, 717-722.
[4] Zhang, H. B., Song, X. G., Jiang, J. H., et al. (2011). Model Test of Mechanical Characteristics of Cantilever Retaining Wall with Mutual Anchor. Applied Mechanics and Materials, 90-93, 508-513. http://dx.doi.org/10.4028/www.scientific.net/AMM.90-93.508
[5] Zhu, Y. P., & Luo, X. H. (2008). The Design of Retaining Structures. Beijing: Higher Education Press.                           eww141219lx
标签：

评论

发表评论

此博客中的热门博文

A Comparison of Methods Used to Determine the Oleic/Linoleic Acid Ratio in Cultivated Peanut (Arachis hypogaea L.)

Cultivated peanut ( Arachis hypogaea L.) is an important oil and food crop. It is also a cheap source of protein, a good source of essential vitamins and minerals, and a component of many food products. The fatty acid composition of peanuts has become increasingly important with the realization that oleic acid content significantly affects the development of rancidity. And oil content of peanuts significantly affects flavor and shelf-life. Early generation screening of breeding lines for high oleic acid content greatly increases the efficiency of developing new peanut varieties. The objective of this study was to compare the accuracy of methods used to classify individual peanut seed as high oleic or not high oleic. Three hundred and seventy-four (374) seeds, spanning twenty-three (23) genotypes varying in oil composition (i.e. high oleic (H) or normal/not high oleic (NH) inclusive of all four peanut market-types (runner, Spanish, Valencia and Virginia), were individually tested ...
发表评论
阅读全文

Location Optimization of a Coal Power Plant to Balance Costs against Plant’s Emission Exposure

Fuel and its delivery cost comprise the biggest expense in coal power plant operations. Delivery of electricity from generation to consumers requires investment in power lines and transmission grids. Placing a coal power plant or multiple power plants near dense population centers can lower transmission costs. If a coalmine is nearby, transportation costs can also be reduced. However, emissions from coal plants play a key role in worsening health crises in many countries. And coal upon combustion produces CO 2 , SO 2 , NO x , CO, Metallic and Particle Matter (PM10 & PM2.5). The presence of these chemical compounds in the atmosphere in close vicinity to humans, livestock, and agriculture carries detrimental health consequences. The goal of the research was to develop a methodology to minimize the public’s exposure to harmful emissions from coal power plants while maintaining minimal operational costs related to electric distribution losses and coal logistics. The objective was...
发表评论
阅读全文

Evaluation of the Safety and Efficacy of Continuous Use of a Home-Use High-Frequency Facial Treatment Appliance

At present, many home-use beauty devices are available in the market. In particular, many products developed for facial treatment use light, e.g., a flash lamp or a light-emitting diode (LED). In this study, the safety of 4 weeks’ continuous use of NEWA TM , a high-frequency facial treatment appliance, every alternate day at home was verified, and its efficacy was evaluated in Japanese individuals with healthy skin aged 30 years or older who complained of sagging of the facial skin.  Transepidermal water loss (TEWL), melanin levels, erythema levels, sebum secretion levels, skin color changes and wrinkle improvement in the facial skin were measured before the appliance began to be used (study baseline), at 2 and 4 weeks after it had begun to be used, and at 2 weeks after completion of the 4-week treatment period (6 weeks from the study baseline). In addition, data obtained by subjective evaluation by the subjects themselves on a visual analog scale (VAS) were also analyzed. Fur...
发表评论
阅读全文