Read full paper at:
www.scirp.org/journal/PaperInformation.aspx?PaperID=50188#.VDHqqlfHRK0
www.scirp.org/journal/PaperInformation.aspx?PaperID=50188#.VDHqqlfHRK0
Author(s)
Traditional DC-DC converter topologies interface two
power terminals: a source and a load. The construction of diverse and
flexible power management and distribution (PMAD) systems with such
topologies is governed by a tight compromise between converter count,
efficiency, and control complexity. The broader impact of the current
research activity is the development of enhanced power converter systems
suitable for a wide range of applications. Potential users of this
technology include the designers of portable and stand-alone systems
such as laptops, hand-held electronics, and communication repeater
stations. High power topology options support the evolution of clean
power technologies such as hybrid-electric vehicles (HEV’s) and solar
vehicles. DC-DC converter is considered as an advanced environmental
issue since it is a greenhouse emission eliminator. By utilizing the
advancement of these renewable energy sources, we minimize the use of
fossil fuel. Thus, we will have a cleaner and pollution free
environment. In this paper, a three-port DC-DC converter is designed and
discussed. The converter was built and tested at the energy research
laboratory at Taibah University, Al Madinah, KSA.
KEYWORDS
Cite this paper
Sharif, S. , Harb, A. , Hu, H. and Batarseh, I.
(2014) An Experimental Simulation of a Design Three-Port DC-DC
Converter. Circuits and Systems, 5, 238-251. doi: 10.4236/cs.2014.510026.
| [1] | Capel, A. (1998) The Power System of the Multimedia Constellation Satellite for the Skybridge Missions. Proceedings of IEEE Power Electronics Specialist Conference, 1913-1930. |
| [2] | Brandhorst, H.W., O’Neill, M.J. and Eskenazi, M. (2003) Photovoltaic Options for Increased Satellite Power at Lower Cost. Proceedings of IEEE Photovoltaic Energy Conversion, 849-852. |
| [3] | Jang, S. and Choi, J. (2008) Energy Balance Analysis of Small Satellite in Low Earth Orbit (LEO). Proceedings of IEEE Power and Energy Conference, 967-971. |
| [4] | Middlebrook, R.D. and Cuk, S.
(1977) A General Unified Approach to Modeling Switching-Converter Power
Stages. International Journal of Electronics, 42, 521-550. http://dx.doi.org/10.1080/00207217708900678 |
| [5] | Cuk, S. (1976) Modeling, Analysis, and Design of Switching Converters. Ph.D. Thesis, California Institute of Technology, Pasadena. |
| [6] | Di Napoli, A., Crescimbini, F., Solero, L., Caricchi, F. and Capponi, F.G. (2002) Multiple-Input DC-DC Power Con- verter for Power-Flow Management in Hybrid Vehicles. Proceedings of IEEE Industry Application Conference, 1578- 1585. |
| [7] | Jiang, W. and Fahimi, B. (2009) Multi-Port Power Electric Interface for Renewable Energy Sources. IEEE 2009 Applied Power Electronics Conference, 347-352. |
| [8] | Imes, W.G. and Rodriguez, F.D. (1994) A Two-Input Tri-State Converter for Spacecraft Power Conditioning. Pro- ceedings of AIAA International Energy Conversion Engineering Conference, 163-168. |
| [9] | Rodriguez, F.D. and Imes, W.G. (1994) Analysis and Modeling of a Two-Input DC/DC Converter with Two Con- trolled Variables and Four Switched Networks. Proceedings of AIAA International Energy Conversion Engineering Conference, 322-327. |
| [10] | Dobbs, B.G. and Chapman, P.L. (2003) A Multiple-Input DC-DC Converter Topology. IEEE Power Electronics Let- ters, 1, 6-9. |
| [11] | Benavides, N.D. and Chapman,
P.L. (2005) Power Budgeting of a Multiple-Input Buck-Boost Converter.
IEEE Transactions on Power Electronics, 20, 1303-1309. http://dx.doi.org/10.1109/TPEL.2005.857531 |
| [12] | Matsuo, H., Lin, W.Z., Kurokawa, F., Shigemizu, T. and Watanabe, N. (2004) Characteristics of the Multiple-Input DC-DC Converter. IEEE Transactions on Industrial Electronics, 51, 625-631. |
| [13] | Solero, L., Caricchi, F., Crescimbini, F., Honorati, O. and Mezzetti, F. (1996) Performance of a 10 kW Power Electronic Interface for Combined Wind/PV Isolated Generating Systems. Annual IEEE Power Electronics Specialists Conference, 2, 1027-1032. |
| [14] | Solero, L., Lidozzi, A. and Pomilio, J.A. (2004) Design of Multiple-Input Power Converter for Hybrid Vehicles. IEEE Applied Power Electronics Conference and Exposition, 2, 1145-1151. |
| [15] | Su, G.J. and Peng, F.Z. (2005) A Low Cost, Triple-Voltage Bus DC-DC Converter for Automotive Applications. IEEE Applied Power Electronics Conference and Exposition, 2, 1015-1021. |
| [16] | Peng, F.Z., Li, H., Su, G.J. and
Lawler, J.S. (2004) A New ZVS Bidirectional DC-DC Converter for Fuel
Cell and Battery Application. IEEE Transactions on Power Electronics,
19, 54-65.
http://dx.doi.org/10.1109/TPEL.2003.820550 |
| [17] | Tao, H., Kotsopoulos, A., Duarte, J.L. and Hendrix, M.A.M. (2005) Multi-Input Bidirectional DC-DC Converter Combining DC-Link and Magnetic-Coupling for Fuel Cell Systems. IEEE Industry Applications Conference, 3, 2021-2028. |
| [18] | Nayfeh, A.H. and Balachandran,
B. (1995) Applied Nonlinear Dynamics. John Wiley, New York.
http://dx.doi.org/10.1002/9783527617548 |
| [19] | Chakrabarty, K., Poddar, G. and
Banerjee, S. (1996) Bifurcation Behavior of the Buck Converter. IEEE
Transactions on Power Electronics, 11, 439-447. http://dx.doi.org/10.1109/63.491637 |
| [20] | Harb, A. and Harb, S. (2012) Chaos and Bifurcation of DC-DC Buck Convertor. Renewable Energy Congress, Sousse, 20-22 December 2012. |
| [21] | Maity, S., Tripathy, D., Bhattacharya, T.K. and Banerjee, S. (2007) Bifurcation Analysis of PWM-1 Voltage-Mode- Controlled Buck Converter Using the Exact Discrete Model. IEEE Transactions on Circuits and Systems I, 54, 1120- 1130. eww141006lx |
评论
发表评论